Power Feed Joiners for Code 70, Code 75 and Code 83 Rail - 4 Pairs

These power feed joiners will help address the worries of soldering that many modellers have: they're the safe, clean and tidy way of bringing power to the track.

Supplied in packs of four pairs, each joiner has a short length of wire securely pre-soldered to it. The modeller just has to subsititute the standard metal joiners for a pair of these where the power feed is required, and pass the wires down through pre-drilled holes on the baseboard. With approximately 8 inches(204mm) of wire on each one there should be plenty of length available to go through most baseboards.

In turn these wires can be connected to longer runs of wiring under the baseboard.

Suitable for HOn3 Code 70, OO/HO Code 75, HOm Code 75 and "83 Line " HO Code 83 rail profiles..

FOR LOW VOLTAGE USE ONLY - 18V MAXIMUM. 3 AMP.