Wet Effects Stain - 1oz

Stir well before applying as stains settle.

Apply stain with a fine brush around detail, seems, recessed and standing detail or apply evenly over entire surface. Stain will naturally concentrate in corners and pull up flat surfaces.

To blend, thin or remove use Enamel Thinner. Let dry for 15 minutes, remove excess with thinner using either a moistened cloth or fine brush.

Leave 24 hours for full cure. Recoating before then may result in blending of colors. Seal with clear coat.

Always test surface compatibility with paint on hidden area or on same type of surface that is not your finished project.

• Thin paint 3 parts paint to 2 parts thinner
• Adjust compressor to 20-25 PSI
• For Aztek Airbrushes use high flow nozzles, Red #9342C, Orange #9343C, or Yellow #9344C
• Other brand airbrushes use a #3 needle
• *NOTE* Solvent based products cannot be shipped outside the UK.